Arrive Alive

                        4x4 Vehicles & Water Crossings

                        4x4 & Water Crossings

                        Water crossings can provide some of the most exhilarating and challenging 4WDriving around. They can also prove to be the most expensive!

                        A 4x4 is not an amphibious vehicle, in fact they are not even waterproof. The actual depth that you can cross depends on your vehicle. For example, a stock Blazer may be submerged at the depth a raised Toyota doesn't even wet the doorsills.

                        As a general rule, if its above the top of your wheels its probably too deep. A water crossing should not be attempted by inexperienced or ill-prepared 4x4 drivers.

                        Prior to a water crossing, it is a good idea to place your recovery gear on top of other luggage. The last thing you want to do is be searching under your cooler, tents and baggage for your recovery gear when you are stuck in the middle of a crossing.

                         

                        Vehicle Preparation

                        The first thing to do before any unfamiliar water crossing is to walk it. If you cannot walk it you cannot cross it. If the water is flowing too quickly to safely walk the crossing, then it cannot be driven across. Remember, vehicles actually float until water seeps into them. When you walk the crossing you are actually starting your vehicle preparation. You are giving the axles, diffs and gearbox time to cool down while you find out exactly how deep the water is.

                         

                        Diff Breathers

                        When a hot axle hits cold water it cools rapidly. This has the effect of lowering the air pressure inside the axle and the diff housing, causing air to be drawn in via the diff breathers. Extending your diff breathers higher up the chassis (standard on most Landcruisers) with the aid of plastic tubing is a "must do" for regular water goers. However, it is no guarantee that water will not enter your diff. The sudden reduction in air pressure inside your diff can still cause water to be drawn in via your axle seals if the diff breathers do not equalize the pressure quick enough. This is why its still necessary to allow the vehicle time to cool down, even when extended diff breathers are fitted.

                         

                        Air Intake

                        Water and engines do not mix very well, and when they do it almost always results in bent pistons, valves and crankshaft commonly called "hydro-locking". If you think this sounds expensive your right. The positioning of the air intake is critical to how well a vehicle can handle a crossing. For example certain Toyota  models have their air intake directly behind the headlight, which is great to allow cold air into the engine but unfortunately is equally as great in directing water into the engine (An easy fix for this is to remove the plastic tubing from the air cleaner to the headlight when crossing water).

                        NEVER attempt a water crossing where the water depth is above the air intake height. If you intend doing regular water crossings, its a good idea to fit a snorkel as it raises the air intake to your roofline. It doesn't mean you can use your 4WD as a submarine!

                         

                        Engine Bay Protection

                        Placing a tarp across the front of the vehicle minimizes water entering the engine bay by creating a bow wave, provided forward momentum is maintained. The result is less water for the radiator fan to spray over the ignition system, less chance of water entering the air intake and less likely for the fan to propel its way up to and through the radiator.

                        Diesel vehicles are usually better for water crossings as you do not have the ignition system to worry about. Water in the ignition system usually results in a stalled engine and not actual engine damage, though this is of little comfort when you find yourself stuck in the middle of a crossing. Depending on the water depth, its advisable to climb out of your window rather than open the door and flood your carpets. To minimize stalling from a wet ignition, it’s a good idea to spray all the ignition system with water repellent beforehand.

                         

                        Radiator Fan

                        While under the hood spraying water repellent, check to see what type of radiator fan is fitted. Most 4WD's these days have the viscous coupling type, which means that when the engine is cool enough the fan doesn't spin at full speed. With the engine off, try and turn the fan. If it turns easily, you will probably get away without having to take off the fan belt. If it doesn't turn easily or yours is the fixed type, then you should remove the fan belt, If you don't and water enters the engine bay, the fan may act as a propeller, bend forward and cut a nice round hole through your radiator. It’s certainly one problem you don't want to discover once you have completed the crossing. Even if it doesn't affect your radiator, you still do not want water being sprayed around, especially in a petrol vehicle.

                         

                        Walking the Crossing

                        When walking your water crossings its best to walk in the intended wheel tracks to find if there are any hidden rocks or potholes, as well as for checking the depth. Potholes at common crossings are often caused by previous vehicles spinning their wheels after hitting a submerged rock. So if you find a pothole, check for submerged rocks. It’s a good idea to place markers at these points so you can avoid them. Its been known for a vehicle attempting a relatively easy crossing to suck in water when a single pothole has caused the hood to momentarily dip below the water level, causing water to enter the air intake, resulting in hydro-lock and a damaged engine.

                         

                        Driving Technique

                        With a mental picture of your route, or better still, with markers in place, and all your vehicle preparation done, its time to start the crossing. Before you enter the water, remember to take off your seat belt and wind down your window.

                        Using low range second gear at 1500-2000 rpm (for most vehicles) creates just the right bow wave. Its important to get the speed just right as too fast will send water everywhere while too slow may flood the engine bay. Hopefully you follow your markers and get to the other side with no problems. But if you do strike problems avoid using the clutch as this may allow water to get between the friction plate and the flywheel, resulting in limited drive.

                        If the wheels start to slip, its important not to over-rev the engine but back-off the accelerator and hope the wheels regain traction. Excessive wheel-spin will not help.

                        If the engine stalls, put the vehicle in neutral without using the clutch and attempt to restart. If luck is on your side the engine will fire up. Now is not a good time to wish you had already disconnected the fan belt, as your engine bay will be flooded. Its normally best to use 1st gear low range and with a minimum of clutch usage, try and extricate yourself from this predicament.

                         

                        Maintenance after Water-crossings

                        So once you have successfully crossed to the other side and are on your way home, you don't need to give the water crossing a second thought, right? Wrong! Any crossing at axle depth or deeper necessitates a checking of the diff oil for water contamination. Having an extended diff breather is not a 100% guarantee of waterproofness and any crossing above your axles without extended cliff breathers should mean a mandatory inspection.

                        Checking your diffs for water contamination is very easy. Since water is heavier than oil, it will collect at the lowest point in the diff, right where the drain plug is located. After allowing time for your vehicle to cool, just loosen the drain bolt and run a small amount (~20mls) of the diff oil into a glass. If you're unlucky enough to have water present, the diff oil should be drained. It is best to flush the diff several times to ensure all traces of water are removed. Milky colored oil also indicates water is present and should also be changed.

                        If you're like the majority of 4WDrivers, you won't be able to change the diff oil until you get home, because you won't have spare oil and a sump pump to change it. If you suspect contaminated oil (a deep water crossing without extended diff breathers or perhaps you have leaking diff seals) then you can try and remove the water by draining the diff until only oil comes out the drain hole. Do not drain too much and leave your diff short of lubrication. Collect this oil and water emulsion as you should never dispose of oil into the environment. Save it till you get back home and dispose of it properly.

                        It's not only diffs than can have water contamination, but also your gearbox, transfer case and engine oil. However, it is usually only when a vehicle is stationary in deep water that these components are contaminated.

                        Amongst other items to check are bar mounted electric winches. These components may not be used for extended periods and when they're needed you may find they have seized up. If the winch has been submerged in water it is advisable to strip it and grease it accordingly. A quick operation of it after a crossing may prove it still works, but you may find out when it seizes that you washed all the grease out 6 months ago!

                        A water crossing is something that should not be taken too lightly as it has the potential to do expensive engine and drive-train damage. However, with the right vehicle preparation and post crossing maintenance, you can enjoy some of the most challenging 4WDriving around.

                         

                        Water Crossing Summary

                        Vehicle Preparation

                        • Walk the crossing to check its depth. 
                        • Don't cross fast flowing water. 
                        • Place markers at hidden obstacles. 
                        • Place a tarp across the front of the vehicle. 
                        • Disconnect the fan belt if a viscous coupling fan is not fitted. 
                        • Spray water repellent on distributor and ignition wires. 
                        • Pack recovery gear on top, ready for use.

                        Driving Technique

                        • Take off seat belt and wind down window. 
                        • Use low range 2nd gear (in most situations). 
                        • Drive at a steady speed to create a bow wave. 
                        • Avoid using the clutch. 
                        • Do not over-rev engine if you lose traction. 
                        • If engine stalls, place in neutral without using clutch to restart. Takeoff in 1st low.


                        Post Watercrossing maintenance

                        • Check diffs etc for water if depth above axles. 
                        • Check winches if fitted. 

                        Information from:
                        Andre Botha
                        Approved Member of African Off-Road Academy 
                        www.just4x4adventures.co.za 
                        andre@just4x4adventures.co.za

                         Also View:

                        Loading...

                        Search Road Safety Articles

                        Latest Pages

                        Driving in Winter / Driving on Snow and Ice

                        Driving in Winter / Driving on Snow and Ice

                        Driving in winter may be hazardous for the unprepared and inexperienced driver. Although South Africa is not as well known for extreme winter conditions, such conditions may be extremely hazardous and many drivers might need to consider measures relating to the condition of their car as well as driving

                        Read More

                        Safe Driving with Trucks in Heavy Rain and in Bad Weather

                        Safe Driving with Trucks in Heavy Rain and in Bad Weather

                        On the Arrive Alive website we find a rather comprehensive section on safe driving in heavy rains and bad weather, but not so much info on the challenges encountered by our truck drivers in these conditions! We discuss safe driving in heavy winds and how other modes of transport can be safer around

                        Read More

                        Safe Driving with Trucks in Strong Winds

                        Safe Driving with Trucks in Strong Winds

                        Not many South Africans are aware that their country has the 10th largest road network in the world. Our large road transport network means that during the daily course of their duties, our truck drivers often encounter adverse weather when out on these roads. Defensive driving is required by truck drivers

                        Read More

                        Road Safety and Your Windscreen

                        Road Safety and Your Windscreen

                        Background information The windscreen is an often neglected component of the vehicle. The windscreen is much more important than a mere screen between you and other road users. The safety needs stretch far beyond the obvious requirement of visibility for the driver! In today's vehicles, windscreens

                        Read More

                        Safety with Grass Cutting, Vegetation Control and Roadside Maintenance

                        Safety with Grass Cutting, Vegetation Control and Roadside Maintenance

                        Introduction On the Arrive Alive website, we have revealed that South Africa has the 10th largest road network in the world - approximately 750,000 km. It should be clear from this that roadside maintenance can be a quite a challenge - and we should pay attention to all those doing road maintenance,

                        Read More

                        Project Help and Road Safety

                        Project Help and Road Safety

                        Introduction On the Arrive Alive website and associated safety portals, we discuss how South Africans can be safe not only from road crashes and crime but also from medical incidents and other emergencies. Technology has become ever more important to summon fast and effective emergency assistance

                        Read More

                        Load More Pages

                        Partners

                        View All

                        任我爽精品视频在线播放